>> Site Map >> Forums >> Post Installation Help [nCo Mod]
Forum module - topics in forum:
Post Installation Help [nCo Mod] - Problems after the installation ask here.
FCK
Hi
I have managed to install fck-Nuke , all seems well until I publish? Then any image that was in preview has gone.. Any ideas ?????
First off FCK Nuke is only supported on 7.6 so if your using any other version of nuke then it WONT WORK PROPERLY.
http://sourceforge.net/project/showfiles.php?group_id=135989
You'll also notice the releases are almost 2 years old, making them seriously outdated.
Second be sure your config.php files allowable html has the image tag as does the example below.
| Code: : |
| $AllowableHTML = array("img"=>2,"tr"=>1,"td"=>2,"table"=>2,"div"=>2,"p"=>2,"hr"=>1,"b"=>1,"i"=>1,"strike"=>1,"u"=>1,"font"=>2,"a"=>2,"em"=>1, "br"=>1,"strong"=>1,"blockquote"=>1,"tt"=>1,"li"=>1,"ol"=>1,"ul"=>1,"center"=>1); |
If it does not then you should add it.
That explains it...Thanks..
I was testing t on nuke 8 first then install it on ultra 7.6 but as you say it is 2 years old.. Is there an alternative to this?
http://nukecode.com/modules.php?name=Downloads&op=getit&lid=1286
make sure your site is using the ultra 7.6.0.3.2 patch
This will seem a dumb question ..But how will I know? It has been installed about 5 days. If you didn't download the 7.6.0.3.2 Patch and install it then you don't have it.
Patch location
Thanks SevenAll installed and upgraded with patch and editor
apart from sentinel 5 seemed a little confusing so left it as 2.2 Thanks again
